Integrated antennas |
- 2.4 GHz, gain 3 dBi, internal omni, horizontal beamwidth 360°
- 5 GHz, gain 5 dBi, internal omni, horizontal beamwidth 360°
|
Interfaces |
- 1 x 10/100/1000BASE-T autosensing (RJ-45), Power over Ethernet (PoE)
- Management console port (RJ-45)
- USB 2.0 (enabled via future software)
|
Indicators |
- Status LED indicates boot loader status, association status, operating status, boot loader warnings, boot loader errors
|
Dimensions (W x L x H) |
- Access point (without mounting bracket): 8.3 x 8.3 x 2 in. (210.8 x 210.8 x 50.8 mm) |
Weight |
- 3.12 lb (1.41 kg) |
Environmental |
Cisco Aironet 1830i
- Nonoperating (storage) temperature: -22° to 158°F (-30° to 70°C)
- Nonoperating (storage) altitude test: 25˚C, 15,000 ft.
- Operating temperature: 32° to 104°F (0° to 40°C)
- Operating humidity: 10% to 90% (noncondensing)
- Operating altitude test: 40˚C, 9843 ft.
|
System |
- 1 GB DRAM
- 256 MB flash
|
Powering options |
- AP1830: 44 to 57 VDC
- Power supply and power injector: 100 to 240 VAC; 50 to 60 Hz
- 802.3af/802.3at
- Enhanced PoE
- Cisco local power supply, AIR-PWR-C=
- Cisco power injector, AIR-PWRINJ5= (Note: This injector supports 802.3af only), AIR-PWRINJ6=
Note: If 802.3af PoE is the source of power, the USB port is disabled.
|
Power draw |
- 15.4W
Note: When deployed using a PoE specification, the power drawn from the power sourcing equipment will be higher by some amount, depending on the length of the interconnecting cable.
|
Physical security |
- Torx security screw, included with the access point
|
Accessories |
- Mounting bracket: AIR-AP-BRACKET-8= (available as spare)
- Physical security kit: AIR-SEC-50= (sold separately), with 50 pcs. security screws used to secure the access point onto wall-mounting bracket, 50 pcs. RJ-45 caps and 2 pcs. unlock keys used to block physical access to Ethernet ports
|
Compliance |
- Safety: UL 60950-1, CAN/CSA-C22.2 No. 60950-1, UL 2043, IEC 60950-1, EN 60950-1
- Radio approvals: FCC Part 15.247, 15.407, RSS-247 (Canada), EN 300.328, EN 301.893 (Europe), ARIB-STD 66 (Japan), ARIB-STD T71 (Japan), EMI and susceptibility (Class B), FCC Part 15.107 and 15.109, ICES-003 (Canada), VCCI (Japan), EN 301.489-1 and -17 (Europe), EN 50385
- IEEE standards: IEEE 802.11a/b/g, 802.11n, 802.11h, 802.11d, IEEE 802.11ac
- Security: 802.11i, WPA2, WPA, 802.1X, AES
- Extensible Authentication Protocol (EAP) types: EAP-Transport Layer Security (TLS), EAP-Tunneled TLS (TTLS) or Microsoft Challenge Handshake Authentication Protocol Version 2 (MSCHAPv2), Protected EAP (PEAP) v0 or EAP-MSCHAPv2, EAP-Flexible Authentication via Secure Tunneling (FAST), PEAP v1 or EAP-Generic Token Card (GTC), EAP-Subscriber Identity Module (SIM)
- Multimedia: Wi-Fi Multimedia (WMM)
- Other: FCC Bulletin OET-65C, RSS-102
|
Software |
Cisco Unified Wireless Network Software Release with AireOS wireless controllers:
- 8.1.121.0 or later for the Cisco Aironet 1830 Series Access Points
|
Deployment modes |
Centralized, standalone, sniffer**, Cisco FlexConnect™, monitor**, OfficeExtend**, mesh**
|
Supported wireless LAN controllers |
- Cisco 2500 Series Wireless Controllers, Cisco 3500 Series Wireless Controllers, Cisco Wireless Controller Module for ISR G2, Cisco Wireless Services Module 2 (WiSM2) for Cisco Catalyst® 6500 Series Switches, Cisco 5500 Series Wireless Controllers, Cisco Flex® 7500 Series Wireless Controllers, Cisco 8500 Series Wireless Controllers, Cisco Catalyst 9800 Series Wireless Controllers, Cisco 5760 Wireless LAN Controller, ** Cisco Catalyst 3650 and 3850 Series Switches with integrated controller**
- Cisco Mobility Express
|
802.11n version 2.0 (and related) capabilities |
- 3x3 MIMO with two spatial streams
- Maximal ratio combining (MRC)
- 20- and 40-MHz channels
- PHY data rates up to 300 Mbps (40 MHz with 5 GHz)
- Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Tx/Rx)
- 802.11 dynamic frequency selection (DFS)
- Cyclic shift diversity (CSD) support
|
802.11ac Wave 1 and 2 capabilities |
- 3x3 MIMO with two spatial streams, single-user or multiuser MIMO
- MRC
- 802.11ac beamforming (transmit beamforming)
- 20-, 40-, and 80-MHz channels
- PHY data rates up to 867 Mbps (80 MHz in 5 GHz)
- Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Tx/Rx)
- 802.11 DFS
- CSD support
|
Bạn đang cần tư vấn về sản phẩm: AIR-AP1832I-S-K9 ?
Chào anh,
Wifi Cisco AIR-AP1832I-S-K9 có thể chạy được 2 mode là Controller base và Mobility Express. Anh vui lòng cung cấp thông tin và hóa đơn mua hàng để được CNTTShop hỗ trợ cấu hình ạ.
Mong nhận được phản hồi từ anh!
Wifi Cisco AIR-AP1832I-S-K9 hỗ trợ tối đa 400 Client trong điều kiện tiêu chuẩn của hãng đưa ra, tuy nhiên sẽ thấp hơn nhiều trong môi trường thực tế.
Bộ phát wifi Cisco AIR-AP1832I-S-K9 có cấu hình như 1 wifi gia đình bình thường anh nhé. Để cài đặt wifi, anh cần có dây console để thay đổi OS của thiết bị sang ME và cài đặt các thông số của thiết bị anh nhé.
Bộ phát wifi Cisco AIR-AP1832I-S-K9 Aironet wireless 1830 Access Point Dual-band, controller-based 802.11a/g/n/ac, Wave 2 internal antennas bảo hành 12 tháng bạn nhé.
Báo giá của wifi Cisco AIR-AP1832I-S-K9 Aironet wireless 1830 Access Point Dual-band, controller-based 802.11a/g/n/ac, Wave 2 internal antennas đã được gửi vào mail, bạn vui lòng check mail nhé.