MLAG Function Configuration

Table 13-1 MLAG function configuration list

Configuration Task
Create one MLAG domain	Create one MLAG domain
Configure the MLAG parameters	Configure the delay time of auto recovery after node restarting
	Specify the local VLAN interface
	Configure the MLAG node ID
	Configure the priority of the MLAG node role
	Specify the peer IP address
	Configure the preemption mode
	Configure the MAC address of the MLAG system
	Configure the priority of the MLAG system
	Configure up state delay time and up state interval time
Configure the Keepalive parameters	Configure the source, source address and other parameters of the Keepalive packet
	Set the sending interval and receiving timeout of the Keepalive packet
	Set the Keepalive quiet period
Configure the Peer-Link	Configure the L2 aggregation interface as the Peer-link port
Configure the MLAG port	Configure the MLAG port
Configure the orphan port	Configure the orphan port of slave node to be set to shutdown state when peer link fails, but keepalive is normal